1000W Mean Well SE-1000 single output power supply
- Buy 102 for $125.00 each and save 3%
- Buy 1002 for $119.00 each and save 8%
We are distributor of Mean Well SE-1000 power supplies, genuine version, not cheap copycat
Feature
Forced air cooling by built-in DC ball bearing fan
High power density 7.3w/inch
With DC_OK signal output
Built-in remote ON-OFF control
Built-in remote sense function
UL / CUL approved
Low cost
2 years warrant
Output
DC output voltage: DC 5V (SE-1000-5), 9V (SE-1000-9), 12V (SE-1000-12, default), 15V (SE-1000-15), 24V (SE-1000-24), 48V (SE-1000-48)
Rated current: 83.3/41.7A
Current range: 0~83.3A/0~41.7A
Rated power: 999.6W/1000.8W
Ripple & noise (max.): 150mVp-p/200mVp-p
Voltage ADJ. range: 10~13.5V/22~27.5V
Voltage tolerance: ±1.0%
Line regulation: ±0.5%
Load regulation: ±0.5%
Setup, rise time: 1500ms, 50ms/230VAC 1500ms, 50ms/115VAC at full load
Hold up time (Typ.): 20ms/230VAC 15ms/115VAC at full load
Input
Voltage range: 90~132V AC/180~264V AC by switch 254~370VDC
Frequency range: 47~63Hz
Efficieny (Typ.): 85%/88%
AC current (Typ.): 17.5A/115VAC 10A/230VAC
Inrush current (Typ.): 35A/115VAC 55A/230VAC
Leakage current: <2.5mA / 240VAC
Over load: 105 ~ 125% rated output power, Protection type : Shut down o/p voltage, re-power on to recover
Over voltage: 13.8 ~ 16.2V/28.0 ~ 32.4V Protection type :Shut down O/P voltage, re-power on to recover
Over temperature: 65~75 celsius (TSW1) detect on heatsink of power transistor Protection type : Shut down O/P voltage, recovers automatically after temperature goes down
DC_OK Signal: PSU turn on:3.3V ~ 5.6V PUS turn off:0 ~ 1V
Remote control: RC+/RC-: 0 ~ 0.8V power on; 4 ~ 10V power off
Working TEMP.: -20 ~ +60 celsius (Refer to "Derating Curve")
Workking humidity: 20 ~ 90% RH non-condensing
Storage TEMP., humidity: -40 ~ +85 celsius, 10 ~ 95% RH
TEMP. coefficient: ±0.05%/ (0 ~ 50 clesius)
Vibration: 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes
Safety standards: UL60950-1 approved
Withstand voltage: I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC
Isolation resistance: I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC / 25 / 70% RH
MTBF: 251.6K hrs min. MIL-HDBK-217F (25 Celsius)
Dimension: 278*127*63.5mm (L*W*H)
Packing: 2.5Kg; 6pcs/16Kg/1.38CUFT
NOTE
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 celsius of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. By using UVP circuit, PSU will not turn on direct by in AC continue ON/OFF condition within 5 sec.
